![]() ![]() ![]() To manually configure the IPv6 address, subnet mask, and (optionally) default gateway, enter:.To manually configure the IPv4 address, subnet mask, and (optionally) default gateway, enter:network parms ipaddress netmask.To use a BootP server to obtain the IP address, subnet mask, and default gateway information, enter:network protocol bootp.To use a DHCP server to obtain the IP address, subnet mask, and default gateway information, enter:network protocol dhcp.If the unit does not have a service port: To view the assigned or configured network address, enter:show serviceport.Serviceport ipv6 address address/prefix-length To disable DHCP/BootP and manually assign an IPv6 address and (optionally) default gateway, enter:. ![]() To disable DHCP/BootP and manually assign an IPv4 address, enter:.To use BootP, change the protocol by entering: serviceport protocol bootp.If your network has a DHCP server, then you need only to connect the switch to your network. To have the address assigned through DHCP:By default, the port is configured as a DHCP client.Depending on whether the unit has a service port, refer to one of the following sections. Using either the web interface or the command line, configure network information as needed.After a successful login, the System Description window opens. By default, the user name is admin, and there is no password. The user name and password are the same as those you use to log on to the command-line interface. Type the user name and password into the fields on the login screen, then click Login. Open a web browser and enter the IP address of the switch in the browser’s address field.ī. At the command prompt, enter enable.You are now in Privileged EXEC command mode.(There is no default password.)After a successful login, the screen shows the system prompt, for example (Extreme 220)>. Power on the switch.After the switch boots successfully, the User: login prompt displays.Configure the terminal-emulation program to use the following settings:.Using a straight-through modem cable, connect a VT100/ANSI terminal or a workstation to the console (serial) port.If you attached a PC, Apple, or UNIX workstation, start a terminal-emulation program, such as HyperTerminal or TeraTerm.If you are managing your 210 or 220 series switch with ExtremeCloud, point your browser to /quickstart to get started. Follow these steps to connect your 210 or 220 series switch to the network and perform first-time configuration.īefore you begin, make sure the switch is installed securely and connected to a power supply. ![]()
0 Comments
Leave a Reply. |